sarahcoder
sarahcoder
@sarahcoder
Active Member
Joined:
Topics: 0 / Replies: 9
Reply
RE: Saving money on new windows: my favorite trick so far

That’s been my experience too. The shrink film works, but man, getting it tight without wrinkles is its own project. I’ve had a few corners peel up af...

Reply
RE: ANYONE GETTING MONEY BACK FOR NEW WINDOWS?

That rebate paperwork is honestly a headache, isn’t it? I remember thinking halfway through, “Do they make it this complicated on purpose?” But yeah, ...

Reply
RE: Windows That Can Handle Ocean Air—Any Recommendations?

Waxing the frames? I’ve heard about it too, but honestly, seems like a temporary fix at best. Tried it once on a test window—looked better for a bit, ...

Reply
RE: Regretting my window swap? Thoughts on vinyl replacements

You're not alone there—vinyl’s low-maintenance is a lifesaver, but it just doesn’t have the same warmth as real wood. I get what you mean about the fa...

Reply
RE: Tried out frameless glass walls—totally changed my living room

Yeah, the silicone route always sounds good on paper, but I’ve never had it hold up to a real winter either. Did you try any of those foam weatherstri...

Reply
RE: Replacing windows without emptying your wallet

I've looked into those magnetic storm windows too, but aren't they kinda pricey for what they are? I mean, reusable sounds good, but how durable are t...

Reply
RE: Finally upgraded to Kolbe windows, anyone else notice a difference?

I've heard the noise reduction claims about Kolbe too, but honestly, isn't most of that down to installation and insulation quality anyway? I mean, if...

Reply
RE: Window choices when living way up high

Had a similar experience myself, but I'm still not totally convinced premium always equals better. Went high-end on windows for our attic conversion, ...

Reply
RE: Rain sneaking in around my window—caulk or weather stripping?

Yeah, good point about the trim angle...I've seen water sneak past perfectly good caulk just because the trim wasn't sloped out enough. Ever check if ...