Yep, totally know that struggle. My front room window has a corner like that—no matter how much caulk or weatherstripping I use, there’s still a draft...

I get where you’re coming from with PETG not holding up in the sun, but I’ve had a bit more luck than most folks seem to. I printed some latches last ...

I tried the magnetic panels on our 1950s windows last winter. Here’s what I did: measured the inside frame, cut the acrylic to fit, then stuck the mag...

I get the “buy once, cry once” logic, but $18k is a chunk of change. Here’s how I’d think about it: first, ask your builder if there are different lin...

I’ve actually got interior storm panels on half my windows—picked up a couple from Indow a few years back when I couldn’t stomach the price of full re...

Tried one of those window repair kits last winter when my porch window cracked. The kit had this clear film you stick over the glass and shrink tight ...

Totally get this. I’ve done the plastic film routine too—hair dryer and all. One trick I found helpful: put a rolled-up towel on the sill overnight to...

Totally agree about the insulating film—used it last winter myself. One tip for anyone struggling with neat application: first, clean and dry the fram...

We had a similar thing happen—switched contractors after the first guy installed windows that didn't even close properly. Luckily, most of it was fixa...

We replaced ours about two years ago, and I noticed pretty similar results. The heating bill didn't suddenly drop like a rock or anything, but after a...