You’re not alone—those plastic kits are tough to disguise, especially in daylight. I’ve tried smoothing them out with a hairdryer, but even then, the ...

I’ve run into that film issue too, and honestly, I’m not convinced deglosser is the best route for vinyl. A lot of folks swear by it, but in my experi...

That’s the problem with spray foam—if you’re not careful, it expands way more than you’d expect and goes everywhere. I’ve seen folks try to use it for...

Energy bills are usually where people hope to see the biggest difference, but honestly, it’s not always night and day. I swapped out all my original s...

That’s a classic—seen more than a few glued gloves (and worse) over the years. Honestly, I get why people try to save money with DIY, but windows are ...

That’s spot on. I’ve seen a lot of seals get trashed from over-cleaning, especially on 90s vinyl. Warm water and mild soap is honestly the way to go—a...

Can’t tell you how many times I’ve seen that—guys just skipping the back dam or pan flashing altogether. Drives me nuts. It’s not even a “maybe” probl...

You’re spot on about the fit—quarter inch gaps might as well be open windows in my experience. I’ve run into the same problem with older homes where n...

I hear you on the whole unlined linen thing—looks great in a catalog, but real life is another story. I’ve seen so many folks swap them out after a fe...

That’s been my experience too—older windows can be a real mixed bag when it comes to hardware compatibility. I remember helping a neighbor with a 1930...